The versatility of Pneumatic excessive strain grouting pumps

Peumatic Grouting pump is designed for stress and filling grouting of cement and bentonite slurries. It is primarily used for injecting (grouting) bar anchors and the drill holes so as to reinforce the free rock mass. The most grain dimension can not exceed zero.2 mm.
Grouting ไดอะแฟรม and maintenance is easy, protected and dependable. This pump is used in mines working beneath troublesome conditions because it’s reliable and explosion-proof.
Basic Pneumatic Grouting pump include: An air inlet, the pneumatic cylinder, mounting base body and stand, stress gauge, pumping cylinder, outlet with quick release coupling and wheels.
How it works

Pneumatic stress within the air cylinder exerts a excessive strain on the grout combination which outcomes in ejection of grout with a high strain and velocity. The valves of the air cylinder within the pump operate automatically to actuate the cylinder. The pneumatic cylinder then strikes the plunger up and down to finish the pumping cycle.
Pneumatic grout pump could be driven even with out Electrical energy provide in distant areas through the use of engine driven compressor.

The pump is majorly used in building and mining industry for injecting material into broad and medium dimension gap in beams, columns ,basement walls and flooring, carry shaft concrete wall fill-up and so forth. In mining industry it’s used to fill up cement answer where there’s a gap exists between construction and rock and for soil stabilization.
Detachable design tends to straightforward maintenance and transportation. Challenging works like Grouting in Bridges.
READ: How hydraulic submersible pumps work

This pump is extensively utilized in tunnels, coal mine, bridges and dams, constructing foundation, and different underground projects, and inflammable, explosive sites and other bad surroundings.
It has utility in chemical trade additionally to pump out chemical slurries.
The pump is electricity free so, can be utilized at any site condition whether or not it’s rural or urban.
Mining Pneumatic Grouting pump has a bigger discharge slurry adjustment vary. Generally the final amount of the grouting quantity is 8 or10 occasions of the amount to begin with. And the ultimate grouting quantity proves that filling is compacted.
Simply put; Pneumatic high-pressure grouting pump is specifically designed for high-pressure grouting. And it adopts full hydraulic drive, it’s stress and flow could be adjusted in accordance with the requirements of grouting,(The circulate of grouting pump is 0-100L/min, stress of discharge is 0-10MPa).besides, This Pneumatic high-pressure grouting pump can be used for grouting single or double fluid.
High-pressure grouting pump is mainly used for highways, railways, water and electrical energy, building, mining and so on. ground/underground development.

Mining Pneumatic Grouting pump has some great benefits of low vitality consumption, small vibration, low noise, small dimension, excessive effectivity, dependable efficiency, strain and move control, lengthy life and so on. Common mine grouting pump has pneumatic injection pump, twin fluid injection pump, extrusion injection pump and piston injection pump.
Pneumatic grout pump can be Light weight and with a wheelie design it could be carried easily. It is designed for easy operation and low upkeep. Last however not least its spare components are easily obtainable.

Scroll to Top