pressure gauge น้ำมัน is designed for pressure and filling grouting of cement and bentonite slurries. It is primarily used for injecting (grouting) bar anchors and the drill holes so as to reinforce the free rock mass. The maximum grain dimension cannot exceed 0.2 mm.
Grouting pump operation and maintenance is simple, secure and dependable. This pump is used in mines operating under troublesome conditions as a result of it’s dependable and explosion-proof.
Basic Pneumatic Grouting pump embrace: An air inlet, the pneumatic cylinder, mounting base frame and stand, stress gauge, pumping cylinder, outlet with fast release coupling and wheels.
How it actually works
Pneumatic strain within the air cylinder exerts a high pressure on the grout mixture which leads to ejection of grout with a excessive stress and velocity. The valves of the air cylinder within the pump perform mechanically to actuate the cylinder. The pneumatic cylinder then strikes the plunger up and down to complete the pumping cycle.
Pneumatic grout pump may be driven even without Electrical power provide in distant areas through the use of engine driven compressor.
Applications
The pump is majorly used in construction and mining business for injecting material into broad and medium dimension hole in beams, columns ,basement partitions and flooring, raise shaft concrete wall fill-up and so forth. In mining industry it is used to refill cement answer the place there’s a gap exists between structure and rock and for soil stabilization.
Detachable design tends to easy maintenance and transportation. Challenging works like Grouting in Bridges.
READ: How hydraulic submersible pumps work
This pump is broadly used in tunnels, coal mine, bridges and dams, constructing basis, and other underground initiatives, and inflammable, explosive sites and other bad surroundings.
It has software in chemical trade additionally to pump out chemical slurries.
The pump is electrical energy free so, can be utilized at any web site situation whether or not it is rural or urban.
Mining Pneumatic Grouting pump has a larger discharge slurry adjustment range. Generally the final quantity of the grouting volume is eight or10 instances of the amount to begin with. And the ultimate grouting quantity proves that filling is compacted.
Simply put; Pneumatic high-pressure grouting pump is specially designed for high-pressure grouting. And it adopts full hydraulic drive, it’s strain and flow can be adjusted according to the requirements of grouting,(The flow of grouting pump is 0-100L/min, strain of discharge is 0-10MPa).besides, This Pneumatic high-pressure grouting pump can be utilized for grouting single or double fluid.
High-pressure grouting pump is principally used for highways, railways, water and electricity, building, mining etc. ground/underground building.
Benefits
Mining Pneumatic Grouting pump has some great advantages of low energy consumption, small vibration, low noise, small dimension, high effectivity, dependable efficiency, stress and flow management, lengthy life and so forth. Common mine grouting pump has pneumatic injection pump, dual fluid injection pump, extrusion injection pump and piston injection pump.
Pneumatic grout pump is also Light weight and with a wheelie design it may be carried easily. It is designed for easy operation and low maintenance. Last but not least its spare parts are easily available.
Share